Page 1 of 1

Cant Transmit Voice

Posted: Sun Jun 10, 2018 10:55 am
by AFankhauser
Hello All,

Im connected to PE right now via XP11 and using the new 737-900 ultimate and i can hear the controllers just fine, however i cant transmit any voice that they hear. APU GEN is on so im not sure its a voltage issue and ive tried binding both contact ATC and transmitt Vx on COM1 yet nothing works. Any ideas?

also,

all my devices are set to default the way they should be.

Re: Cant Transmit Voice

Posted: Sun Jun 10, 2018 2:53 pm
by Kevin_atc
Did you try rebooting the sim? Occasionally I have issues where a simple reboot of xplane will fix it.

Re: Cant Transmit Voice

Posted: Wed Jun 13, 2018 7:13 am
by Keith Smith
If it was voltage related then you wouldn't be hearing anything at all. Can you verify this is all happening on COM1?

I'd wait until you hear the controller or a pilot talking then briefly hold down your PTT without speaking. If you continue to hear voice, then you're not transmitting on that radio. If the voice cuts out then you are transmitting, but might be transmitting dead air if the mic is muted or if it's using a different audio input device than what you might be thinking.

Re: Cant Transmit Voice

Posted: Wed Jun 20, 2018 6:22 am
by AFankhauser
So i found my issue. I remapped my bind for "Contact ATC" from my keyboard to my joystick. This seemed to take care of it. Not sure why i cant use my keyboard for this.

Re: Cant Transmit Voice

Posted: Fri Jul 20, 2018 11:16 am
by Keith Smith
Keyboard commands only work if X-Plane is the active application. Joystick buttons work at all times.