Page 1 of 1

[solved] After logging on can't control plane

PostPosted: Sun Sep 02, 2012 11:57 am
by rick223
Get everything set on 2004, log on and call up, get clearance, then as soon as try to move just go in a circle to right. Get out,reset, get back on in the air , get flight following, try to land and can't get lower without excessive trim, then crash after on the ground.Suggestions?

Re: After logging on can't control plane

PostPosted: Mon Sep 03, 2012 11:40 am
by Keith Smith
Have you verified that the plane only behaves this way once connected to PE?

I did hear of one xplane pilot who had the ptt key also mapped to elevator trim.

Any chance you have something going on?

Keith

Re: After logging on can't control plane

PostPosted: Mon Sep 03, 2012 12:08 pm
by rick223
Yes Keith, only does it when logged on . flies just fine otherwise. Have PPT tied to" Enter" Key.Thanks

Re: After logging on can't control plane

PostPosted: Mon Sep 03, 2012 1:06 pm
by Alex Stjepanovic
IIRC, in MSFS "0", "." and "enter" are rudder commands.

Re: After logging on can't control plane

PostPosted: Mon Sep 03, 2012 2:45 pm
by rick223
MORON alert!!!!!!!! Rudder yaw on PPT button. Changed , works now ....Idiot :?

Re: After logging on can't control plane

PostPosted: Mon Sep 03, 2012 5:17 pm
by Keith Smith
Rick, "moron" is a really strong word. Really, and I think I speak for everyone here, when I say that we think of you more as a buffoon.

;)

Glad you got it solved.

Re: [solved] After logging on can't control plane

PostPosted: Mon Sep 03, 2012 8:54 pm
by Steven Winslow
Yep, buffoon.....much more appropriate terminology. ;)

Re: [solved] After logging on can't control plane

PostPosted: Tue Sep 04, 2012 6:32 pm
by Mark Hargrove
Or perhaps even a bassoon, since that's a woodwind and wind plays such an important role in flying.