Page 1 of 1

Drones only appear as Red Tags, not aircraft

Posted: Thu Mar 06, 2014 4:56 pm
by Calvin Waterbury
This may be handled elsewhere, but I could not locate anything usable.

After attempting to locate drones visually I discovered none could be seen even at ~2nm unless the MSFS red tags were turned on. I verified the PE models were in multiplayer tab. How do I make the drones/aircraft models visible?

Thanks.

Re: Drones only appear as Red Tags, not aircraft

Posted: Thu Mar 06, 2014 7:09 pm
by Keith Smith
It's an artifact of FS2004/FSX. The planes are very difficult to see without the tags.

X-Plane makes them quite a bit easier to see (even with lights off).

Re: Drones only appear as Red Tags, not aircraft

Posted: Tue Sep 30, 2014 12:26 pm
by Calvin Waterbury
I'm running a little behind, but did the new FS9 PE Client improve this or is it a problem with FS9?
Thanks.

Re: Drones only appear as Red Tags, not aircraft

Posted: Tue Sep 30, 2014 6:36 pm
by Keith Smith
It's an artifact of FS2004/FSX.
We tell the sim to draw planes and the sim draws the planes. The situation hasn't changed. FWIW, spotting a plane visually at more than 2 miles away is actually quite difficult in real life during the day.

Re: Drones only appear as Red Tags, not aircraft

Posted: Tue Sep 30, 2014 7:44 pm
by Calvin Waterbury
Keith Smith wrote:
It's an artifact of FS2004/FSX.
We tell the sim to draw planes and the sim draws the planes. The situation hasn't changed. FWIW, spotting a plane visually at more than 2 miles away is actually quite difficult in real life during the day.
Thanks for the clarification. You must be a mind reader. I was going to post the question about distance visibility since I was thinking about it earlier this afternoon. The fact the AI planes are not that visible has been good practice for my out-of-cockpit awareness. When I "fly" I am constantly scanning the skies, especially when my synthetic ATC indicates other aircraft are in the area.