Newbie Help / GTN
Posted: Sun Jan 17, 2021 3:54 pm
Back on PE after some time, previous experience was limited.
My first departure (KABQ VFR with Flight Following Requested) was a failure after getting scolded by the controller for not turning on my transponder, then again for not using Mode C. Simulation-wise I was squawking the proper code w/ altitude reporting using the F1 GTN in P3Dv5.1 (A2A Bonanza). I let the controller know it was a sim problem and was going VFR as I was outside of Albuquerque Class C at that point. Changed to 1200 and set myself on plan/ cruise. I then looked at the live map and PE Aware and saw myself progressing on the map. I noticed the map reports COM1/ and it showed COM2 when I set it to monitor 121.5. Map apparently does not show any Squawk codes (understandable).
Does anybody have suggestions on how to verify if my Transponder is being received? I don't want to get all set up again and find out there is an issue once airborne.
Also, searching the forums does seem there have been issues with the GTN - does anybody have a current solution and/or know if the RXP units in P3D are any better?
Thanks for any thoughts.
Joe L.
My first departure (KABQ VFR with Flight Following Requested) was a failure after getting scolded by the controller for not turning on my transponder, then again for not using Mode C. Simulation-wise I was squawking the proper code w/ altitude reporting using the F1 GTN in P3Dv5.1 (A2A Bonanza). I let the controller know it was a sim problem and was going VFR as I was outside of Albuquerque Class C at that point. Changed to 1200 and set myself on plan/ cruise. I then looked at the live map and PE Aware and saw myself progressing on the map. I noticed the map reports COM1/ and it showed COM2 when I set it to monitor 121.5. Map apparently does not show any Squawk codes (understandable).
Does anybody have suggestions on how to verify if my Transponder is being received? I don't want to get all set up again and find out there is an issue once airborne.
Also, searching the forums does seem there have been issues with the GTN - does anybody have a current solution and/or know if the RXP units in P3D are any better?
Thanks for any thoughts.
Joe L.