Since the client update, AI lights are once again visible! I did run into one issue, though. While the AI Nav and strobe lights are in the correct positions, they hover several feet away from the aircraft. Anyone else experiencing this?
Todd
AI lights are back but hover in mid-air
AI lights are back but hover in mid-air
Regards,
Todd
Todd
-
- Posts: 3
- Joined: Mon Jun 23, 2014 11:31 am
Re: AI lights are back but hover in mid-air
Hi Todd
I am a trial member till 1st July and was flying in the pattern at John Wayne yesterday. I had the same issue where the lights were about 20 ft adrift of where they should actually be.
I also experienced this on the ramps where I could here jet noise, see lights about 200 ft apart but no jet?
I sat on the ramp connected to the network and watched a few others flying the pattern and every aircraft that had strobes on caused the same issue.
Paul
I am a trial member till 1st July and was flying in the pattern at John Wayne yesterday. I had the same issue where the lights were about 20 ft adrift of where they should actually be.
I also experienced this on the ramps where I could here jet noise, see lights about 200 ft apart but no jet?
I sat on the ramp connected to the network and watched a few others flying the pattern and every aircraft that had strobes on caused the same issue.
Paul
Re: AI lights are back but hover in mid-air
Hello,
I'm uncertain if anyone was able to have a look at this. I believe I have the latest client installed. As the above posts indicate, the lights of other aircraft seem to hover a great distance from the actual aircraft. That distance seems to very, on some occasions, the lights appear several hundred yards in front of user aircraft as they were on final and landed. Is there perhapse a setting on my end that I can change that might help? P3D 2.4
Cheers
I'm uncertain if anyone was able to have a look at this. I believe I have the latest client installed. As the above posts indicate, the lights of other aircraft seem to hover a great distance from the actual aircraft. That distance seems to very, on some occasions, the lights appear several hundred yards in front of user aircraft as they were on final and landed. Is there perhapse a setting on my end that I can change that might help? P3D 2.4
Cheers