PilotEdge Forums

Hi guys,

As the title of the thread says I have an issue with the Flight1 GTN 750. I have it installed into both the A2A 182 Skyline and the Real Air duke Turbine. In the Duke it works fine but in the A2A 182 Skylane the Pilotedge P3D client does not recognise any frequencies set on Com1 or the transponder on the GTN 750. But the client does recognise frequencies set on Com2 on the standard radio stack in the 182. As it works fine on the Real Air Duke but not in the A2A 182 does anyone know why that would be?

David

I'm flying A2A C182 with GTN750+GTN650 and it all works fine. However by default GTN750 cannot switch transmit from COM1 to COM2 in this model. Small Lua script was needed to fix that. But there where no problems with PE client not recognizing GTN750 as COM1 source.

You could try to run GTN config tool and check settings for 750 in your C182 and (maybe) allow it to rewrite panel.cfg. Or as another option - try to rerun C182 GPS setup and switch to default GPS and back. Or I can send you my working copy of panel.cfg I you want to try it.

Solved it. Had to do a complete sim reinstall anyway so thought would be a good idea to get it done and its solved the issue.