How to exit a hold thats part of a DP?

Post Reply
PenfoldPilot
Posts: 38
Joined: Mon Jan 12, 2015 2:44 pm
Location: KAJZ
Contact:

How to exit a hold thats part of a DP?

Post by PenfoldPilot »

If I fly a hold that's part of a DP when is the correct time/location to exit it? I'm thinking you finish the inbound to the vor/fix and then continue on from there, but I had something happen to me this week that confuses me, should I just exit mid hold when I reach the altitude described in the DP?

Thanks
Keith Smith
Posts: 9939
Joined: Sat Oct 09, 2010 8:38 pm
Location: Pompton Plains, NJ
Contact:

Re: How to exit a hold thats part of a DP?

Post by Keith Smith »

practically speaking, I can't think of many situations where it will make much of a difference either way.
PenfoldPilot
Posts: 38
Joined: Mon Jan 12, 2015 2:44 pm
Location: KAJZ
Contact:

Re: How to exit a hold thats part of a DP?

Post by PenfoldPilot »

Keith Smith wrote:practically speaking, I can't think of many situations where it will make much of a difference either way.
I'll give that a go and see how it ends up. Lots of info out there for getting into a hold but not obvious how to leave one if not given ATC instruction.
sono
Posts: 59
Joined: Mon Apr 10, 2017 9:11 pm

Re: How to exit a hold thats part of a DP?

Post by sono »

For an obstacle departure procedure (ODP), you may have to climb in a hold until the altitude mentioned in the procedure. Once you are at that altitude I cannot see it matters as you say.

The example plate just says "proceed enroute"

(Jepp plates have an advantage over FAA in that that ODP are shown directly on the airport plates)
Image
PE CAT-11, I-11, SKY-8
EASA and FAA (61.75) Private ASEL AMEL Instrument
Post Reply