Page 2 of 2
Re: Traffic and COM issue - first time setup
Posted: Wed Jan 15, 2014 2:34 pm
by blemoine
Actually because I did not hear anything, I did not try. The stock plane works (tested it), just can not see the instruments.
Re: Traffic and COM issue - first time setup
Posted: Thu Jan 16, 2014 5:48 pm
by currentadventure
Try switching the com switch up. That's what I have to do to be able to hear anything.
Re: Traffic and COM issue - first time setup
Posted: Fri Jan 17, 2014 6:41 am
by blemoine
I had tested with them up and down. I change to the float model and the COM's worked but NAV1 & 2 stopped. I could only get on beep code and it did not match. When I changed back to the normal model and the COM's worked, with the same NAV issue. This was after uninstalling and reinstalling the C172. So I then tested the X-Plane default 172 and its not working now.
I'm going to start over with x-plane and see what I get. I changed from FSX because it was locking up and a pain to get working. I never thought getting a SIM setup would be so much work. I look forward to flying one day! LOL
Can anyone comment on P3D, is it less problematic?
Are the Saitek products (switch panel, yoke, rudder, COM/NAV, FIP, etc...) working with it?
Thanks again.