How to test what the transponder sends?
Posted: Fri Jan 12, 2018 6:13 pm
Hi!
I made several flights in the Pilotedge network with the Flightfactor A320 Ultimate and now I had problems with the transponder.
My feeling is, that this was the first controller really checking my transponder signal since I did it as always and have
not changed the simulator or aircraft.
The ground controller told me, that the transponder is not in altitude reporting mode.
When I clicked on ident he could se me for some seconds, but then the transponder switched back off and didn't send anything.
So how can one solve this? Which dataref should carry what value on ground and in flight? Or is there any software I can install to see the side of the controller?
My setting was like this:
Many thanks,
joomie
I made several flights in the Pilotedge network with the Flightfactor A320 Ultimate and now I had problems with the transponder.
My feeling is, that this was the first controller really checking my transponder signal since I did it as always and have
not changed the simulator or aircraft.
The ground controller told me, that the transponder is not in altitude reporting mode.
When I clicked on ident he could se me for some seconds, but then the transponder switched back off and didn't send anything.
So how can one solve this? Which dataref should carry what value on ground and in flight? Or is there any software I can install to see the side of the controller?
My setting was like this:
Many thanks,
joomie