PilotEdge Forums

Out of the blue, I cannot connect with the PE client. After selecting an aircraft and clicking 'Connect', I get an error dialog that says "An error has occured. Click OK to abort SquawkBox. (11). Screen shot below:
The are only two new things about my FSX/PE setup since the client last worked (which was just this past weekend):
(1) I installed AivlaSoft's Electronic Flight Bag add-on and (2) I had just added a new aircraft, a Cessna Citation immediately before this problem.

I've tried removing the recently-added Citation, restarting FSX and rebooting my system -- none of these things helped. I'll try removing the AivlaSoft EFB add-on next (it would be a real bummer if that was the problem, but PE is more valuable to me than the EFB).

Any suggestions? Any idea what the error dialog means?

Disregard. I rebooted one more time and the problem went away.

That was weird.

-M.

Very odd. Not sure what was happening there, sorry.

I am having the exact same problem. I deleted the aircraft I added and restarted a few times. Did you do anything else??

Tony,

Verify headset is connected and is configured as the default recording device?

That worked..Thanks