PilotEdge Forums

Hey Folks,

Just updates X-Plane on my MAC to 10.20 and I no longer have access to the PilotEdge plugin. I reinstalled te Plugin and it still does not show up on XPlane.

Mike

You are probably running the 64-bit version of X-Plane. Run the 32-bit and you'll should be good. We don't have a 64-bit mac plugin yet. Moving this to the X-Plane forum, btw.

Is there a way to tell xplane to run in 32bit?

Thanks for the quick reply!

Mile

There are two files in the root X-plane folder to start the program. One is 64 bit and one is 32 bit.

PilotEdge or 64 bit X-Plane or PilotEdge or 64 bit X-Plane...so many decisions now

For mac, that is the call for now, yes.

I got a PE dedicated X-Plane 10.11 install with scenery that covers only the PE area. Takes up about 4GB on my hard drive. Rendering settings are lower so I don't run into X-Plane running out of memory issues and I keep the frame rate high. I found that with the fancy autogen enhancements of X-Plane 10.20 the memory issue in 32 bit is even worse, so X-Plane 10.20 is for me for 64 bit only, so I'm not using X-Plane 10.20 for PE. My 10.20 install is for off line flying in 64 bit only.

Yup, want to practice ATC communications then it's XP10.11. Want gorgeous flying—XP10.20. It will be a lovely day when we can do both. But such a 1st World problem.