IFR departure from Palm Springs

Post Reply
flyingdrill
Posts: 271
Joined: Sun Jun 22, 2014 4:15 am

IFR departure from Palm Springs

Post by flyingdrill »

Hi
Say I wanted to do a route going on V386 to PMD. Looking at the DPs, I could be given the fairly intensive VOR work in the Cathedral One DP, or the Palm Springs Five DP, which merely involves turning to a heading then maintaining an assigned altitude and getting vectors (quite a bit less labor intensive!). Can any of you regular RW (or PE) So-Cal pilots or controllers tell me which of the two DPS may be given, which is given more often, and why?

Regards
Steven Winslow
Posts: 459
Joined: Tue Oct 12, 2010 8:51 pm
Location: KBZN - Bozeman, MT
Contact:

Re: IFR departure from Palm Springs

Post by Steven Winslow »

I absolutely love the CATH1.PSP departure! It's not bad at all. Give it a go and I think you'll enjoy it. I usually file the CATH1.PSP departure and I've never been given anything different. I've never flown it real world, but I've done it numerous times on PE.
Steven Winslow
CEO/Owner - Air Northwest Virtual Airlines • http://www.airnorthwest.org
People should get what they want when they want it once in a while. Keeps them optimisitic.
Peter Grey
Posts: 5716
Joined: Tue Oct 12, 2010 3:21 pm

Re: IFR departure from Palm Springs

Post by Peter Grey »

In terms of assignment. The CATH departure is normally assigned to departures from runway 31L/R and the Palm Springs departure is normally assigned to departures from runway 13L/R.

However a pilot request for another DP is normally honored.
Peter Grey
PilotEdge Director of Quality Assurance and Operations
peter@pilotedge.net
flyingdrill
Posts: 271
Joined: Sun Jun 22, 2014 4:15 am

Re: IFR departure from Palm Springs

Post by flyingdrill »

Thank you Steven, and thank you Peter.

I just flew (not on PE) the CATH DP in Carenado's 206 in X-Plane 10.30, and it was fine. I had actually got to my 10000' required altitude easily before the final run in to the PSP VOR, so no hold required. Could be trickier in a plane with an arthritic climb rate ;)

Peter's response does give me the heads up on what is likely to be expected.

Regards
Ryan B
Posts: 856
Joined: Mon Mar 05, 2012 2:37 pm

Re: IFR departure from Palm Springs

Post by Ryan B »

If you're VMC you can always tell the controller you can maintain separation from obstacles and terrain and get a turn on course sooner. That's usually what I do after turning to the VORTAC.
PE ID: 29
FAA ATCS
FAA PPL ASEL
flyingdrill
Posts: 271
Joined: Sun Jun 22, 2014 4:15 am

Re: IFR departure from Palm Springs

Post by flyingdrill »

Ryan. A man who knows how to cut his workload :D
Post Reply