67L (Mesquite) underground?

[bbuckley]

Flying FSX (I know...) anyone know why the runway at 67L disappears just inside 4nm and the taxiway appears to be in a ditch. I was flying a Phenom 100 and after the runway suddenly disappeared I did a low approach, saw the ditch taxiway and went around. I opted to land in the dirt where the runway should have been and took this screenshot after rollout and turning slightly to see it.
--Bruce

[bbuckley]

It was a tough departure today from Rwy 19 @ 67L...

[Kerbo]

Remarks:

• OBSTACLE AT END OF RUNWAY IS 30FT WALL OF SOLID EARTH

[ridikamus]

ORBX FTX Vector can cause this. If you have it installed, run the configuration tool that comes with it (I think it's called "FTX Vector Configuration Tool") and go to the "Airport Elevation Corrections" tab. Add the airport you're having trouble with (67L in this case) to the "AEC DISABLED" box and see if that fixes it.

[bbuckley]

Remarks:

• OBSTACLE AT END OF RUNWAY IS 30FT WALL OF SOLID EARTH

ORBX FTX Vector can cause this. If you have it installed, run the configuration tool that comes with it (I think it's called "FTX Vector Configuration Tool") and go to the "Airport Elevation Corrections" tab. Add the airport you're having trouble with (67L in this case) to the "AEC DISABLED" box and see if that fixes it.

Thanks. I do have the ORBX FTX Vector Freeware NA Airports installed but I can't find the FTXConfigurator tool. I checked the ORBX website briefly but I'll give it a better check and let you know.
Thanks, ---Bruce