KCRQ DME

[CrackerJack]

This is a really strange question but I'm not sure what to do next.

I was practicing for the I2 which ends with flying the ILS rwy 24 into KCRQ.

Here is the strange thing for whatever reason I can get the localizer and GS but nothing shows up on the DME??? I fly Prepard3d v3. I have tested with both the A2A C182 and the Turbine Duke and in both cases I have the ILS but no DME? I of course have the DME set to 108.7.

I have never had a case where there was a DME but I get no signal in the SIM!! Any suggestions??

Thanks!

[Kyle.Sanders]

Check for corrupt NavData. Check and make sure the DME info for the ILS is there in the file.

If anything, update NavData just in case.

[stevekirks]

I'm loading up the sim now to check this. I'm using FSX:SE with the updated ILS/navaids from here: http://www.aero.sors.fr/navaids3.html

That site software will work on P3D also.

I'll post back my results.

[stevekirks]

I'll post back my results.

Same result for me: No DME reported on the ILS

[snglecoil]

Yeah, I had to edit the airport in Airport Design Editor to enable DME. There may be other tools out there that can do it, but I'm not sure. I haven't checked since installing ORBX SoCal. Maybe they updated it with the recent release, but I'm pretty sure even their freeware KCRQ was still missing the DME.

[CrackerJack]

I also have Orbx SoCal installed. I'm going to post this in the Prepard3D forums on AVSIM and LM's site.