Is there a problem with comms right now 2300z?

Post Reply
sidfadc
Posts: 74
Joined: Mon Oct 24, 2016 11:38 am

Is there a problem with comms right now 2300z?

Post by sidfadc »

So I've just flown into KPSP Twr on 119.70, made my call 10 miles out and.........nothing. I've flown VFR from Big Bear on CTAF and only switched to KPSP about 15 miles out. I changed to San Bernadino Tower to test and....nothing. I'm connected to the network and done some MIC tests and it is working fine. Never had a problem before so I'm a bit puzzled. I had to disconnect and land offline. I've reconnected but the problem persists.

Is the service fully operational? Right now in my time zone it's 2301z.

Thanks
Sid
sidfadc
Posts: 74
Joined: Mon Oct 24, 2016 11:38 am

Re: Is there a problem with comms right now 2300z?

Post by sidfadc »

Hmmm never mind disconnected again and reconnected all fine. Strange.
Keith Smith
Posts: 9943
Joined: Sat Oct 09, 2010 8:38 pm
Location: Pompton Plains, NJ
Contact:

Re: Is there a problem with comms right now 2300z?

Post by Keith Smith »

Hi Sid,

No known issues at this time. The controller on duty is working traffic and speaking with 7 other aircraft. Send an email to support with your specific sim and the method you're using the trigger the push to talk, then we can help you out.
Matthias Geiss
Posts: 149
Joined: Wed Sep 02, 2015 2:24 am

Re: Is there a problem with comms right now 2300z?

Post by Matthias Geiss »

We had a short (probably 1-2 minutes) "ATC outage" at around 2000z. But I don't know if it was a general issue or if it was just the one controller we were talking to in that moment.
Keith Smith
Posts: 9943
Joined: Sat Oct 09, 2010 8:38 pm
Location: Pompton Plains, NJ
Contact:

Re: Is there a problem with comms right now 2300z?

Post by Keith Smith »

If it was right at the top of the hour, it might've been a controller shift swap, and the relieving controller may not have configured their audio correctly.
sidfadc
Posts: 74
Joined: Mon Oct 24, 2016 11:38 am

Re: Is there a problem with comms right now 2300z?

Post by sidfadc »

ok thanks
Post Reply